Takata Maxi Instruction Manual download pdf (Page 20)

1616

CAUTION!

Ensure that the shoulder belt remains in the shoulder

belt guide.

Step 2 – Place the child in the seat

Seat your child in the TAKATA MAXI.

Step 3 – Put the seatbelt on and fasten it

[MAXI_036] Thread the lap belt beneath the red lap

belt guides on the base of the seat. [MAXI_037 +

MAXI_038] The bottom end of the shoulder belt

should also be fed beneath the lap belt guide on the

side of the buckle. Fasten the seatbelt, by pressing the

tongue into the buckle of the seat where the TAKATA

MAXI is positioned.

Step 4 – Check everything

Ensure that your child is seated and secured correctly

in the TAKATA MAXI. Use the following checklist to

do this.

Checklist – using the TAKATA MAXI in a vehicle:

Please check that

• the TAKATA MAXI is used with a vehicle seat that

the manufacturer has labeled as suitable for this class

of child seat;

• the TAKATA MAXI is facing forwards;

• the TAKATA MAXI is secured with an approved

three-point seatbelt;

• both connection arms are ﬁ rmly attached to the

ISOFIX points (if available);

• the top of your child’s head is below the top edge of

the headrest;

• the shoulder belt guide is around two ﬁ nger widths

above the child’s shoulder;

• the shoulder belt runs through the seatbelt guide,

with the clasp closed;

• the shoulder belt runs over the middle of the

shoulder, and does not touch the neck;

• the lap belt runs beneath the two red lap belt guides;

• the bottom end of the shoulder belt runs beneath the

lap belt guide on the side of the buckle;

• the tongue of the belt is locked securely into the

buckle;

• the vehicle seatbelt runs snugly over the child, and is

not twisted.

6. CARE AND MAINTENANCE

Removing the covers

Step 1 – Remove the seat back

Remove the back of the TAKATA MAXI as described

in Section 3 – Basic instructions (Removing the seat

back).

Step 2 – Remove the seat back cover

[MAXI_039] Unfasten the two straps at the top and

bottom of the seat back cover, and loosen the cover

around the size indicator.

Step 3 – Remove the side wing covers

[MAXI_040] To remove the covers on the wings,

unfasten the two buttons (one on each wing) on the

inside and the four buttons (two on each wing) on the

outside. The two wing covers can then be pulled off at

the front.

Step 4 – Remove the crash pads from the side wing

covers

WARNING!

[MAXI_041] Each wing cover contains crash pads

that are not washable. To do this, simply pull them out

of the inside pockets of the covers.

Step 5 – Remove the headrest cover

[MAXI_042] Unfasten the two buttons on the back of

the headrest, and the two hooks in the upper area of

the inner side. Loosen the cover by twisting it towards

you and lifting it up from the bottom. Then unfasten

the last two hooks on the edge of the headrest’s bottom

and pull the cover down and off.

Step 6 – Remove the crash pad (AIRPADS) from the

headrest cover

WARNING!

[MAXI_043] The headrest cover contains crash pads

(AIRPADS) that are not washable. To do this, simply

pull the crash pads (AIRPADS) out of the two inside

pockets.

Step 7 – Remove the seat base cover

[MAXI_044] Unfasten the two straps on the seat base

cover (one strap on each side), positioned on the outer

sides of the armrests (if this has not already been

done), and pull the cover towards you, off both

armrests. [MAXI_045] Then unfasten the four straps

on the underside of the base, and the two in the

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 53 54

Comments to this Manuals

No comments

Takata Maxi Instruction Manual Page 20

Comments to this Manuals

Related products and manuals for Car seats Takata Maxi